laserman's blog

Image via Wikipedia

Ein erster kurzer Test von Knoppix 6.0 auf meinem Notebook:
Es startet wirklich sehr schnell. LXDE gef?llt mir. Am Bootpromt:
knoppix … dann passt die Bildschirmaufl?sung nicht, man sieht nur ein Viertel des Desktops. Mit fb1024x768 statt knoppix ist dieses Problem gel?st.

ACPI/DSDT: der L?fter geht nicht aus. Speedstep und Akku?berwachung sind aber o.k.

WLAN mit Atheros AR5212/AR5213 funktioniert gut mit network manager, trotz dieser Treiber-Meldungen in dmesg:


[ 1849.005813] ath5k phy0: can't reset hardware (-11)
[ 1849.005821] phy0: failed to set freq to 2417 MHz for scan
[ 1850.158119] wlan0: authenticate with AP XX:XX:XX:XX:XX:XX
[ 1850.159707] wlan0: authenticated
[ 1850.159718] wlan0: associate with AP XX:XX:XX:XX:XX:XX
[ 1850.178266] wlan0: RX AssocResp from XX:XX:XX:XX:XX:XX (capab=0x411 status=0 aid=
1)
[ 1850.178275] wlan0: associated
[ 1850.178956] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 1861.119846] wlan0: no IPv6 routers present
[ 1878.331783] ath5k phy0: noise floor calibration timeout (2412MHz)
[ 1878.911012] ath5k phy0: noise floor calibration timeout (2417MHz)
[ 1878.911023] ath5k phy0: can't reset hardware (-11)
[ 1878.911032] phy0: failed to set freq to 2417 MHz for scan
[ 1918.325263] ath5k phy0: noise floor calibration timeout (2412MHz)
[ 1918.325274] ath5k phy0: can't reset hardware (-11)
[ 1918.325281] phy0: failed to set freq to 2412 MHz for scan
[ 1918.663002] ath5k phy0: noise floor calibration timeout (2417MHz)
[ 1918.663011] ath5k phy0: can't reset hardware (-11)
[ 1918.663018] phy0: failed to set freq to 2417 MHz for scan


This entry was posted on Friday, January 30th, 2009 at 4:50 pm and is filed under linux. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.